| Mode of Packing |
I. Component : 2.5 kg / II. Component (Hardener): 2.5 kg |
| Definition |
It is a epoxy resin based putty, which has two components. |
| Color |
White |
| Uses of... |
It can be safely used on metal surface for improve the surface defects. |
| Specifications |
It is flexible epoxy putty, which strongly adheres to surface and resists to chemical materials. It should be sandpapered after 24 hours. |
| Technical Features |
Type of Resin : Epoxy Resin / Polyamide Hardener
Specific Gravity (g/ml) (20 °C) : 1.70 ± 0.05
Glossy : Matt.
Solid Content (by weight) (%) : 96 ± 1
Solid Content (by volume) (%) : 85 ± 1
Flash Point (°C) : 25
Heat Resistance (Dry) ( °C ) : 140
Theoretical Coverage : 1 m²/lt (500 µ dry film thickness)
Practical Coverage : 0,4 - 0,8 m²/kg (500 µ dry film thickness)
Mixing Ratio(by weight):I.Component:50/II.Component(Hardener):50
Pot Life (20 °C) : 3 hours.
Dry film thickness (one coat application) : 500 µ - 2 mm
Drying Time (20 °C- Relative Humidity 85%) : It should be sandpapered after 24 hours.
Thin Down Ratio : It is ready to use and not need thinner. If the necessity of thin, ıt should be thinned with some Merepoks Epoxy Thinner.
|
| Application 1 |
All application surface must be clean, dry and free from oil. It should be applied on on surface of primered with suitable epoxy primer. |
| Application 2 |
Epoxy Putty and hardener components should be mixed well observe to mixing ratio. 5 - 10 minutes waited after components mixing, Merepoks Epoxy Putty is applied on surface with trowel or spatula. It should be sandpapered after 24 hours. After than sandpaper dust and other dirt cleaned, the topcoat paint can be apply. |
| Storage Conditions |
It should be storaged in original and closed containers at 5 - 35 °C temperatures for one year. It should be protected from extreme heat and moisture |
| Important Notices |
Two components must be mixed well.
The mixture should be prepared enough as small parts. The mixing ratio should be considered for paint wastage.
The ambient temperature should be between 5 - 35 °C at the time of application
Application tools must be cleaned with Merepoks Epoxy Thinner, after the application,.
Paint doesn’t empty into drains.
Application procedures defined above should be strictly observed.
|
