| Mode of Packing |
2.5 lt, 7.5 lt and 15 lt. |
| Definition |
Acrylic copolymer binder based, silicone, matt, exterior wall paint. |
| Color |
According to colour card. |
| Uses of... |
It can be safely used on exterior surface of concrete, plaster, mineral substrate etc... |
| Specifications |
Due to silicone structure, it has high vapour permeability, low water absorption and high alkaline resistance. The painted surface is continuously dry, therefore moisture easily put out. It is environment friendly, resists to against friction, washing, sunlight and bad effects of salty moisture in the seaside. |
| Technical Features |
Type of Resin : Acrylic copolymer - Silicone Emulsion
Viscosity (KU)(25 °C) : 134 ± 3
Specific Gravity (g/ml) (20 °C) : 1.55 ± 0.03
Solid Content (by weight) (%) : 66 ± 2
Glossy ( 85° - Gloss ) : 7 ± 3
pH : 8.00 - 9.00
Theoretical Coverage : 16 m²/lt ; 10 m²/kg. (30µ dry film thickness)
Practical Coverage : 0.070 - 0.090 lt/m² ( one coat ) 0.110 - 0.140 kg/m² ( one coat )
Recommended number of coats : Two coats.
Drying Time (20 °C) : Drying : 1 - 2 hours Full drying : 24 hours
Thin Down Ratio : 20 - 25% ( with water- by volume )
|
| Application 1 |
All application surface must be sound, dry and clean Old painted, blistered and dirty surface must be cleaned by scratching and puttied Merbolin Exterior Putty to take sound and smooth surface. After putty application, the surface should be primered with Merbolin Silicone Modified Exterior Primer or Merboizolan Insulation Primer as one coat. |
| Application 2 |
2 - 4 hours after primer application, Merbolin Lux Silicone Modified Exterior Paint, which is applied with brush or roller, is thinned with 20 - 25% (by volume) water. It should be applied as two coats, allowing 1 - 3 hours between the coats. |
| Storage Conditions |
It should be storaged in original and closed containers at 5 - 35 °C temperatures. It should be protected from extreme heat, moisture and frost. |
| Important Notices |
Paint must be mixed before the use.
The ambient temperature should be between 5 - 35 °C at the time of application
Application tools must be cleaned with water, after the application,.
After the application, the painted surface must be protected during
3 days, from chemical and physical factors.
Paint doesn't empty into drains.
Application procedures defined above should be strictly observed.
|
